|
關注：1
2013-05-23 12:21
求翻譯：把FBK用接近開關裝到編碼器安裝支架左側最里面的一個安裝孔上，注意正反方向。兩邊先不要鎖緊螺母，然后把軸上的圓環上的螺釘松開，把螺釘調整到對準接近開關的位置，然后鎖緊螺釘。然后調節接近開關至螺釘頭2mm處，把接近開關鎖緊。是什么意思？ 待解決
 懸賞分：1
- 離問題結束還有
把FBK用接近開關裝到編碼器安裝支架左側最里面的一個安裝孔上，注意正反方向。兩邊先不要鎖緊螺母，然后把軸上的圓環上的螺釘松開，把螺釘調整到對準接近開關的位置，然后鎖緊螺釘。然后調節接近開關至螺釘頭2mm處，把接近開關鎖緊。
問題補充： |
|
2013-05-23 12:21:38
With fbk proximity switch mounted to the encoder installation bracket left side of the innermost mounting holes, pay attention to the positive and negative direction. Both sides do not lock nut first, then the axis of the rings on the screws loosen the adjustment screw to align close to the switch,
|
|
2013-05-23 12:23:18
With the FBK close to switch to the encoder installed inside the left side of the bracket mounting holes on a attention, both positive and negative direction. Both sides do not lock nut on the shaft, and then to the screws on the circle, and adjust the screws to align to the position of the switch,
|
|
2013-05-23 12:24:58
Installs FBK with the close switch to the encoder installs left side of the support on a most inside installment hole, attention pro and con direction.Nearby two do not have to lock the nut first, then loosens on the axis on ring bolt, screw adjustment alignment close switch position, then gib screw
|
|
2013-05-23 12:26:38
Encoder FBK proximity switch mounted to left side of the mounting bracket on the innermost one mounting hole, attention to the positive and negative directions. Don't lock nuts on both sides, and then put the ring on the shaft of the screw loosened, proximity switch position adjusting screws to alig
|
|
2013-05-23 12:28:18
正在翻譯，請等待...
|
湖北省互聯網違法和不良信息舉報平臺 | 網上有害信息舉報專區 | 電信詐騙舉報專區 | 涉歷史虛無主義有害信息舉報專區 | 涉企侵權舉報專區
