As shown in Figure 7, the two methods varied side gear tooth root bending stress distribution in the tooth width direction of the trend, the maximum tooth root bending stress near the inner end, but the new method to get the side gear teeth root bending stress is relatively small by about 9%.

As shown in Figure 7, the two end-tooth is derived from the root of tooth tooth bending stress distribution width direction of the trend, and the most basic tooth root bending stresses are present in close to the end, however, the new ways to get the maximum end-tooth is tooth bending stress relativ

As shown in Figure 7, two method obtained end tooth plate tooth root bending stress in tooth width direction distributed tendency basic one, the biggest tooth root bending stress appears in the nearness inner end place, but the new method obtains the end tooth plate biggest tooth root bending stress

As shown in Figure 7, end tooth disk two method of tooth root bending stress in the tooth width direction of distribution of basic, maximum tooth root bending stress appears near the end, but the new method the end tooth disk maximum tooth root bending stress around relatively small 9%.

正在翻譯，請等待...