Figure 5 and Figure 6 shows that the entire work of the two methods from the side gear tooth surface are in full contact, meet the design requirements. In contrast, the load on the new method to get the side gear tooth surface throughout the work more evenly distributed, but at the same location, th

From Figure 5 and figure 6, the two methods can be seen from the end-plate the entire work surface of the teeth are in full compliance with the design, contact state requirements. In contrast, the new ways to get on the end of the tooth is the load distribution across the work surface of the teeth,

And Figure 6 may know by Figure 5, two method obtained end tooth plate entire work tooth face is at contacts the condition completely, conforms to the design requirement.Compares says, the new method obtains on the end tooth plate load is evener in the entire work tooth face distribution, moreover i

Figure 5 and Figure 6 show, two methods of serration disc the entire tooth surfaces are in contact State, comply with the design requirements. In contrast, new methods are on the end tooth disk loads throughout the tooth surface more uniform distribution of work, and in the same place, 6% per cent l

正在翻譯，請等待...