|
關注：1
2013-05-23 12:21
求翻譯：按壓F1自動鍵，無法捕捉到穩定的波形。A，波形輸入幅值過小；B，被測信號頻率低于20Hz；C，探頭衰減設置不對；D，超出測量頻率范圍；E，被測信號干擾大；F，探頭損壞或連接有誤；G，整機故障。是什么意思？ 待解決
 懸賞分：1
- 離問題結束還有
按壓F1自動鍵，無法捕捉到穩定的波形。A，波形輸入幅值過小；B，被測信號頻率低于20Hz；C，探頭衰減設置不對；D，超出測量頻率范圍；E，被測信號干擾大；F，探頭損壞或連接有誤；G，整機故障。
問題補充： |
|
2013-05-23 12:21:38
Press the F1 key automatically, can not capture a stable waveform. A, the input waveform amplitude is too small; B, the measured signal at frequencies below 20Hz; C, the probe attenuation setting right; D, beyond the measurement frequency range; E, the measured signal interference large; F, the prob
|
|
2013-05-23 12:23:18
acupoints F1 automatic type, unable to capture stable waveform. A, waveform input in such a small value; B detected signals, frequency of less than 20 Hz; C probe attenuation settings, not to exceed; D measuring frequency range; E detected signal interference, the damage or connections; F probe, mis
|
|
2013-05-23 12:24:58
Holds back the F1 automatic key, is unable to catch the stable profile.A, the profile input peak-to-peak value excessively is small; B, was measured the signaling frequency is lower than 20Hz; C, the probe head weakens the establishment not to be right; D, surpasses the survey frequency range; E, wa
|
|
2013-05-23 12:26:38
Pressing F1 key, cannot capture the waveform into the stable. A, waveform input amplitude is too small; b, the measured signal frequency is lower than 20Hz;C, probe attenuation setting wrong; d, exceeds the measurement frequency range; e, the measured signal interference; f, the probe is damaged or
|
|
2013-05-23 12:28:18
Press the F1 key automatically, can not capture a stable waveform. A, the input waveform amplitude is too small; B, the measured signal at frequencies below 20Hz; C, the probe attenuation setting right; D, beyond the measurement frequency range; E, the measured signal interference large; F, the prob
|
湖北省互聯網違法和不良信息舉報平臺 | 網上有害信息舉報專區 | 電信詐騙舉報專區 | 涉歷史虛無主義有害信息舉報專區 | 涉企侵權舉報專區
