However, because the first workpiece in the process some errors, causing the program is not a complete run down the entire piece, and check the entry point there are some not very good, so we started second workpieces.

However, since a workpiece processing, there are some errors in the process resulted in the program is not a full run down, and the entire workpiece inspection that there are, at some not so good, so we started the workpiece 2 processing.

But because in the first work piece processing process has some mistakes, causes the procedure is not the complete movement gets down the entire work piece, moreover inspects an item of spot to have some is not too good, therefore we start the second work piece processing.

But because the first artifacts some errors in the process, leading to program is not a complete run down the entire workpiece, and check point there are not very good, so we may begin a second workpiece machining.

However, because the first workpiece in the process some errors, causing the program is not a complete run down the entire piece, and check the entry point there are some not very good, so we started second workpieces.